Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Question about the gain-boosting method for OTA

Status
Not open for further replies.
N

nathanee

Junior Member level 3
Junior Member level 3
Joined
May 1, 2004
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
239
gain-boosting OTA

Hi, there,

In order to improve the gain of an OTA, the gain-boosting method is an useful thchnique.
what is the relationship between main OTA, and "A" shown in the figure?
Supposed that the UGB of main OTA is 200MHz, how about the opamp "A"?
Is any systematic calculation document?


37_1216308544.jpg
 

gain-boosting OTA

Since you are only boosting at low frequencies, I do not see a reason to have gain at frequencies you do not want to boost.

So first design your main amp. Find the -3dB point of the open loop gain. Then make the boost amps with a UGBW slightly higher then that -3dB point.

This could cause a slow settling behavior though.
 

Re: gain-boosting OTA

the UGBW of A is near to the UGBW of main OTA, that is ok
 

Re: gain-boosting OTA

Read the material that ljy4468 provided. Be careful about the relationship of UGBW between booster and main amplifier, which may cause doublet.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top