Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

IPC STANDARD FOOTPRINTS

Status
Not open for further replies.

san2004

Member level 1
Member level 1
Joined
Jun 26, 2007
Messages
40
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,286
Activity points
1,597
0603 footprint

Dear Frnds,
Is there any IPC Standard document available for footprints specially for smd packages like PQFP, LQFP, DFN etc.How much should be length more than actual pad e.g. 5 mils, 10 mils or 20 mils etc.
Also for 0402 & 0603 components how much should be pad length & width more than the actual component size 0402 -- 1mm x 0.5 mm so what should be pitch & pad size ?
Thanks in advance,
Byee...
 

ipc footprint

The document is "IPC-7351A Generic Requirements for Surface Mount Design and Land Pattern Standard". You have to buy it from www.ipc.org.

The size of the pad depends on where you are using the footprint. IPC-7351A gives the specs for three different footprint sizes - Least, Norminal, and Most. Those footprint sizes are based on the density of the board on which you are using the footprint. "Most" size is used on low density boards, "Nominal on moderate density boards, and "Least" on high density boards.

If you want to look at the recommended footprints, without buying the standard, you can download a free viewer at: **broken link removed**

There's more info available at: **broken link removed**
 

    san2004

    Points: 2
    Helpful Answer Positive Rating
ipc footprints

There is a free viewer available for this at h**tp://www.pcblibraries.com/

As hey are the ones that defined the IPC STD it is the same.
 

    san2004

    Points: 2
    Helpful Answer Positive Rating
0402 pad size

Thanks a lot frnds !!:D:D
 

    V

    Points: 2
    Helpful Answer Positive Rating
0402 footprint

cyberrat said:
There is a free viewer available for this at h**tp://www.pcblibraries.com/
As hey are the ones that defined the IPC STD it is the same.

This is the same viewer available from the IPC footprints site. I just didn't want to give the PCBlibraries bunch a free commercial. They're a manipulative, money grubbing pack of thieves.
 

pcb footprint standard

senilicus said:
Check for the IPC document

That's an outdated copy of the standard. The effective standard is now IPC-7351A, and the method of calculating the footprint pad size has changed completely in the new standard.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top