Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PIC12F675 coding/Reading on PCB

Status
Not open for further replies.
S

Sborbel

Newbie level 2
Newbie level 2
Joined
Nov 3, 2017
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
19
Hi guys a new to this forum hoping I could get some assistance.

Firstly I would like to explain of my device

I currently have a device that has a PIC12F675 I/SN 1505

The device is basically a photoresistor catch and release device using a servo to open and close running of a 3.7 lipo battery

1. Is it possible to read the PIC12F675 from the board with out removing it ?

2. Can someone assist in helping me code a PIC12F675 to do such where by using the photoresistor as the trigger to open and close the servo. ?
 

1 - You can put a ICSP connector (pin header 5x1).

Like this:

ICSP.png


2 - Show what you have done in your code, compiler used, etc...
 

Thank you I will have to try this and check .I will report back

If the chip is protected if I still read it will it affect the chip ?

. Can someone assist in helping me code a PIC12F675 to do such where by using the photoresistor as the trigger to open and close the servo.
 

You cannot read a protected mcu!!!

You may post what you have done in your code, compiler used, etc... so we can help you!!!

If you want someone to make it for you, hire it!!!

There is always someone who can create the project for you!!!

Get started learning how AD converter works... how write code into mcu, etc...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top