FlyingDutch
Advanced Member level 1
- Joined
- Dec 16, 2017
- Messages
- 458
- Helped
- 45
- Reputation
- 92
- Reaction score
- 55
- Trophy points
- 28
- Location
- Bydgoszcz - Poland
- Activity points
- 5,020
Hello,
I am trying to make working Microblaze soft-processor with "PmodCAN" shield from Digilent. I am using "Vivado 2018.2" on Windows 10 PC box. My FPGA board is "Cmod A7" (from Digilent) width Artix 7 chip. Here is link to this board:
https://reference.digilentinc.com/reference/programmable-logic/cmod-a7/start?redirect=1id=cmod_a7/cmhttp://
Here is link to "PmodCAN" shied which I am using:
https://store.digilentinc.com/pmod-can-can-2-0b-controller-with-integrated-transceiver/
I am following this tutorial:
https://reference.digilentinc.com/learn/programmable-logic/tutorials/pmod-ips/start
I stalled after point 7 of this tutorial (after adding interrupts from Pmod module). I don't konw how to connect outputs from "PmodCAN" to AXI bus (AXI GPIO).
My block desing looks like on these screen shots:
Here is link to my project (Vivado 2018.2) on my Google drive:
**broken link removed**
I will be grateful for any help.
Regards
I am trying to make working Microblaze soft-processor with "PmodCAN" shield from Digilent. I am using "Vivado 2018.2" on Windows 10 PC box. My FPGA board is "Cmod A7" (from Digilent) width Artix 7 chip. Here is link to this board:
https://reference.digilentinc.com/reference/programmable-logic/cmod-a7/start?redirect=1id=cmod_a7/cmhttp://
Here is link to "PmodCAN" shied which I am using:
https://store.digilentinc.com/pmod-can-can-2-0b-controller-with-integrated-transceiver/
I am following this tutorial:
https://reference.digilentinc.com/learn/programmable-logic/tutorials/pmod-ips/start
I stalled after point 7 of this tutorial (after adding interrupts from Pmod module). I don't konw how to connect outputs from "PmodCAN" to AXI bus (AXI GPIO).
My block desing looks like on these screen shots:
Here is link to my project (Vivado 2018.2) on my Google drive:
**broken link removed**
I will be grateful for any help.
Regards
Last edited: