Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
assigning Designator to components autmoaticall through software option is annotation, like (C1, R1 etc) ...
however if you want them to go to their previous original designator you can use back annotation.
If suppose you have done some changes in Layout and would like to transfer those changes to schematics then you can use back annotation option which will update the changes.Generarrly it is used after renaming the refdes in layout,before gerber release.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
