Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by fhongjin

  1. F

    What is a CSDF block

    Hi guys, I am trying to learn IQ calibration in an RF transiever. There is a block named CSDF. I really need some help on what it does and what’s the circuit’s structure.
  2. F

    [SOLVED] Complex Filter

    I am now using one pair of signals (one for I and one for Q) and here is the single-ended circuit diagram just as an example. mine are fully differential
  3. F

    [SOLVED] Complex Filter

    Hi Barry, To my knowledge, a complex filter moves a real LPF to the right to filter out image signals. I applied AC signal to Iin and Qin. The two input signals have a 90 degree phase difference. Then,I got Iout and Qout from AC analysis in Cadence. And both of the outputs showed a lowpass...
  4. F

    [SOLVED] Complex Filter

    I got two outputs but they are low pass. I didn’t see the shift of the lowpass filter. That’s why I am confused. Do you get two bandpass response on each output ports if you feed two quadrature input signal?
  5. F

    [SOLVED] Complex Filter

    Hi Fvw, The filter I’m designing is used in an RF receiver to filter out the image signal. And I fed an IQ signal to the filter. I think the input signals should be quadrature so I set a 90 phase difference between the two. I got 2 output signals and I don’t know how to analyze them. Could you...
  6. F

    [SOLVED] Complex Filter

    Hi LvW, Thank you for replying And yes I did get 2 output signals. But I don’t know how to analyze the outputs. For example, if I want to see the bandwidth of a normal low pass filter, I just need to do an AC analysis and plot its frequency response right? However, I don’t know how to visually...
  7. F

    [SOLVED] Complex Filter

    Hi, I’m trying to simulate a complex filter recently and I am having a hard time finding a way to combine the outputs (Q and I). I am using two ac sources as inputs and there are 90 phase shift between them. But I don’t quite understand how to interpret the outputs. Is there a way to plot the...

Part and Inventory Search

Back
Top